Cisco Cisco Packet Data Gateway (PDG)
SGTP Service Configuration Mode Commands
gtpu ▀
Command Line Interface Reference, StarOS Release 17 ▄
8579
gtpu
This command configures the GPRS Tunneling Protocol user data plane parameters (GTP-U) for this SGTP service.
Product
eWAG
PDG/TTG
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > SGTP Service Configuration
configure > context context_name > sgtp-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-sgtp-service)#
Syntax
gtpu { bind address ipv4_address | echo-interval interval_seconds | echo-retransmission {
exponential-backoff [ [ min-timeout timeout_seconds ] [ smooth-factor smooth_factor ] + ]
| timeout timeout_seconds } | max-retransmissions max_retransmissions | retransmission-
timeout timeout_seconds | sync-echo-with-peer
exponential-backoff [ [ min-timeout timeout_seconds ] [ smooth-factor smooth_factor ] + ]
| timeout timeout_seconds } | max-retransmissions max_retransmissions | retransmission-
timeout timeout_seconds | sync-echo-with-peer
no gtpu { bind address ipv4_address | echo-interval | sync-echo-with-peer}
default gtpu { echo-interval | echo-retransmission | max-retransmissions |
retransmission-timeout | sync-echo-with-peer }
retransmission-timeout | sync-echo-with-peer }
no
Removes the configuration for the specified parameter from the current SGTP service configuration.
default
Resets the specified GTP-U parameter to its factory default.
bind address ipv4_address
Defines the GTP-U Gn’ interface IP address that binds to this SGTP service.
The
The
gtpu
and the
gtpc
commands should be configured with the same bind address.
ipv4_address
: Enter a standard dotted-quad IPv4 address.
echo-interval interval_seconds
Configures the echo interval.
interval_seconds
: Enter an integer from 60 through 3600.
Default: 60