Cisco Cisco Packet Data Gateway (PDG)
Subscriber Configuration Mode Commands
overload-disconnect ▀
Command Line Interface Reference, StarOS Release 17 ▄
8799
overload-disconnect
Sets the threshold parameter for overload disconnect.
Product
ASN-GW
HA
PDIF
PDSN
PHSGW
PDG/TTG
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > Subscriber Configuration
configure > context context_name > subscriber { default | name subscriber_name }
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-subscriber)#
Syntax
overload-disconnect [ threshold { inactivity-time inactivity_time_threshold | connect-
time connect_time_threshold } ]
time connect_time_threshold } ]
[ default | no ] overload-disconnect [ threshold { inactivity-time | threshhold connect-
time } ]
time } ]
threshold inactivity-time inactivity_time_threshold
Sets the inactivity time threshold (in seconds) as an integer from 0 through 4294967295. The default value of
zero disables this feature. If
zero disables this feature. If
inactivity-time
for the subscriber’s session is greater than
inactivity_time_threshold
, the session becomes a candidate for disconnection.
threshold connect-time
connect_time_threshold
Sets the connection time threshold (in seconds) as an integer from 0 through 4294967295. A value of zero
disables this feature. If connect-time for the subscriber’s session is greater than
disables this feature. If connect-time for the subscriber’s session is greater than
connect_time_threshold
,
the session becomes a candidate for disconnection.
default
Enables the default condition for this subscriber.
no
Disables the overload disconnect feature for this subscriber. This is the default condition for PDIF.