Cisco Cisco Packet Data Gateway (PDG)
Call Control Profile Configuration Mode
local-cause-code-mapping auth-failure ▀
Command Line Interface Reference, StarOS Release 16 ▄
1925
local-cause-code-mapping auth-failure
Configures the reject cause code to send to a UE when an authentication failure occurs.
Product
MME
Privilege
Administrator
Mode
Exec > Global Configuration > Call Control Profile Configuration
configure > call-control-profile profile_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-call-control-profile-profile_name)#
Syntax
local-cause-code-mapping auth-failure emm-cause-code { eps-service-not-allowed-in-this-
plmn | network-failure | no-suitable-cell-in-tracking-area | plmn-not-allowed | roaming-
not-allowed-in-this-tracking-area | tracking-area-not-allowed }
plmn | network-failure | no-suitable-cell-in-tracking-area | plmn-not-allowed | roaming-
not-allowed-in-this-tracking-area | tracking-area-not-allowed }
remove local-cause-code-mapping auth-failure
remove local-cause-code-mapping auth-failure
Removes the configured cause code mapping.
auth-failure emm-cause-code { eps-service-not-allowed-in-this-plmn | network-
failure | no-suitable-cell-in-tracking-area | plmn-not-allowed | roaming-not-
allowed-in-this-tracking-area | tracking-area-not-allowed }
failure | no-suitable-cell-in-tracking-area | plmn-not-allowed | roaming-not-
allowed-in-this-tracking-area | tracking-area-not-allowed }
Specifies the EPS Mobility Management (EMM) cause code to return when an authentication failure occurs.
eps-service-not-allowed-in-this-plmn
network-failure
no-suitable-cell-in-tracking-area
plmn-not-allowed
roaming-not-allowed-in-this-tracking-area
tracking-area-not-allowed
Usage
Use this command to configure the cause code returned to a UE when an authentication failure occurs. By
default, the MME sends the UE the #3 - Illegal MS cause code when encountering an authentication failure.
This condition occurs for TAU and ATTACH procedures in the following cases:
default, the MME sends the UE the #3 - Illegal MS cause code when encountering an authentication failure.
This condition occurs for TAU and ATTACH procedures in the following cases:
The Authentication response from the UE does not match the expected value in the MME.
Security Mode Reject is sent by the UE.