Cisco Cisco Packet Data Gateway (PDG)
Context Configuration Mode Commands I-M
lac-service ▀
Command Line Interface Reference, StarOS Release 16 ▄
2525
lac-service
Enters the LAC Service Configuration Mode, or is used to add or remove a specified L2TP Access Concentrator (LAC)
service.
service.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration
configure > context context_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ctx)#
Syntax
[ no ] lac-service name
no
Removes the specified lac-service from the current context.
name
Specifies the name of a LAC service to configure, add, or remove as an alphanumeric string of 1 through 63
characters that is case-sensitive.
characters that is case-sensitive.
Important:
Service names must be unique across all contexts within a chassis.
Usage
Enter the LAC Service Configuration Mode for an existing service or for a newly defined service. This
command is also used to remove an existing service.
A maximum of 256 services (regardless of type) can be configured per system.
command is also used to remove an existing service.
A maximum of 256 services (regardless of type) can be configured per system.
Caution:
Large numbers of services greatly increase the complexity of management and may impact overall
system performance (i.e. resulting from such things as system handoffs). Therefore, it is recommended that a large
number of services only be configured if your application absolutely requires it. Please contact your local service
representative for more information.
number of services only be configured if your application absolutely requires it. Please contact your local service
representative for more information.
Example
To add a new LAC service named
LAC1
and enter the LAC Service Configuration Mode, enter the following
command:
lac-service LAC1
To configure an existing LAC service named
LAC2
, enter the following command: