Cisco Cisco Packet Data Gateway (PDG)
Context Configuration Mode Commands S-Z
▀ threshold available-ip-pool-group
▄ Command Line Interface Reference, StarOS Release 16
2698
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end
of the polling interval.
The following table describes the possible methods for configuring IP pool utilization thresholds:
of the polling interval.
The following table describes the possible methods for configuring IP pool utilization thresholds:
Table 24. IP Pool Utilization Thresholds - Configuration Methods
Method
Description
Context-level
A single IP pool utilization threshold can be configured for all IP pool groups within a given system context. If a
single threshold is configured for all pool groups, separate alerts or alarms can be generated for each group.
This command configures that threshold.
single threshold is configured for all pool groups, separate alerts or alarms can be generated for each group.
This command configures that threshold.
IP address
pool-level
pool-level
Each individual IP address pool can be configured with its own threshold. Thresholds configured for individual
pools take precedence over the context-level threshold that would otherwise be applied (if configured).
In the event that two IP address pools belonging to the same pool group are configured with different thresholds,
the system uses the pool configuration that has the greatest low threshold for that group.
pools take precedence over the context-level threshold that would otherwise be applied (if configured).
In the event that two IP address pools belonging to the same pool group are configured with different thresholds,
the system uses the pool configuration that has the greatest low threshold for that group.
Example
The following command configures a context-level IP pool utilization low threshold percentage of
10
and a
high threshold of
35
for an system using the Alarm thresholding model:
threshold available-ip-pool-group 10 clear 35