Cisco Cisco Packet Data Gateway (PDG)
Crypto Map IPSec Dynamic Configuration Mode Commands
▀ set
▄ Command Line Interface Reference, StarOS Release 16
2874
set
Configures parameters for the dynamic crypto map.
Product
ePDG
FA
GGSN
HA
HeNBGW
HNBGW
HSGW
MME
P-GW
PDSN
S-GW
SAEGW
SCM
SecGW
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > Crypto Map Dynamic Configuration
configure > context context_name > crypto map policy_name ipsec-dynamic
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-crypto-dynamic-map)#
Syntax
set { control-dont-fragment { clear-bit | copy-bit | set-bit } | isakmp natt
[keepalive
[keepalive
time ] | pfs { group1 | group2 | group5} | phase1-idtype { id-key-id |
ipv4-address } [ mode { aggressive | main } ] | phase2-idtype { ipv4-address |
ipv4-address-subnet} | security-association lifetime { keepalive | kilo-bytes
ipv4-address-subnet} | security-association lifetime { keepalive | kilo-bytes
kbytes
| seconds
secs
} | transform-set
transform_name
[ transform-set
transform_name2 ...
transform-set
transform_name6
]
}
no set { pfs | security-association lifetime {keepalive | kilo-bytes | seconds }
| phase1-idtype | phase2-idtype | transform-set
| phase1-idtype | phase2-idtype | transform-set
transform_name
[ transform-set
transform_name2 ...
transform-set
transform_name6
] }
no
Deletes the specified parameter or resets the specified parameter to the default value.