Cisco Cisco Packet Data Gateway (PDG)
Crypto Map IPSec Manual Configuration Mode Commands
▀ set peer
▄ Command Line Interface Reference, StarOS Release 16
2896
set peer
Configures the IP address of the peer security gateway that the system will establish the IPSec tunnel with.
Product
ePDG
FA
GGSN
HA
HeNBGW
HNBGW
HSGW
MME
P-GW
PDSN
S-GW
SAEGW
SCM
SecGW
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > Crypto Map Manual Configuration
configure > context context_name > crypto map map_name map_number ipsec-manual
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-crypto-manual-map)#
Syntax
[ no ] set peer
gw_address
no
Removes a previously configured peer address.
set peer
gw_address
Specifies the IP address of the peer security gateway with which the IPSec tunnel will be established.
Usage
Once the manual crypto map is fully configured and applied to an interface, the system will establish an
IPSec tunnel with the security gateway specified by this command.
IPSec tunnel with the security gateway specified by this command.