Cisco Cisco Packet Data Gateway (PDG)
Ethernet Interface Configuration Mode Commands
▀ ip ospf dead-interval
▄ Command Line Interface Reference, StarOS Release 16
3610
ip ospf dead-interval
Configures the interval that the router should wait, during which time no packets are received and after which the router
considers a neighboring router to be off-line.
considers a neighboring router to be off-line.
Product
PDSN
HA
GGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > Ethernet Interface Configuration
configure > context context_name > interface interface_name broadcast
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-if-eth)#
Syntax
[ no ] ip ospf dead-interval seconds
no
Returns the value to its default of 40 seconds.
seconds
Specifies the interval (in seconds) as an integer from 1 through 65535. This number is typical four times the
hello-interval. Default: 40
hello-interval. Default: 40
Usage
Use this command to set the dead intervals for OSPF communications.
Example
To set the dead-interval to
100
, use the following command;
ip ospf dead-interval 100