Cisco Cisco Packet Data Gateway (PDG)
Exec Mode Commands (D-S)
▀ sgs vlr-recover
▄ Command Line Interface Reference, StarOS Release 16
4096
sgs vlr-recover
This command enables active recovery of Circuit Switched Fall Back (SMS-only) UEs when a failed VLR becomes
responsive again.
responsive again.
Product
MME
Privilege
Security Administrator, Administrator
Mode
Exec
The following prompt is displayed in the Exec mode:
[local]host_name#
Syntax
[no] sgs vlr-recover sgs-service sgs_svc_name duration minutes backoff-timer seconds[ -
noconfirm ]
noconfirm ]
no
Resets the command to its default setting of disabled.
sgs-service sgs_svc_name
Specifies the SGs service to which the VLR belongs.
sgs_svc_name
specifies the name for a pre-configured SGs service.
duration minutes
Specifies the amount of time in minutes over which all qualifying UEs will be recovered.
The MME splits this duration into n intervals, 5 seconds apart. A maximum of 50 subscribers will be
processed per interval. For example, a setting of 2 minutes with 100 subscribers would result in the MME
processing all subscribers in the first 2 intervals (10) seconds. Any subscribers remaining at the expiry of the
duration will not be processed.
The MME splits this duration into n intervals, 5 seconds apart. A maximum of 50 subscribers will be
processed per interval. For example, a setting of 2 minutes with 100 subscribers would result in the MME
processing all subscribers in the first 2 intervals (10) seconds. Any subscribers remaining at the expiry of the
duration will not be processed.
minutes
must be an integer from 1 through 3000.
backoff-timer seconds
Specifies the period of time the MME will wait following the detection of a recovered VLR before starting
the VLR recovery actions.
the VLR recovery actions.
seconds
must be an integer from 1 to 3000.
-noconfirm
Indicates that the command is to execute without additional prompt and confirmation from the user.