Cisco Cisco Packet Data Gateway (PDG)
Exec Mode show Commands (D-G)
show diameter route table ▀
Command Line Interface Reference, StarOS Release 16 ▄
4437
show diameter route table
Displays the Diameter routing table.
Product
All
Privilege
Security Administrator, Administrator, Operator, Inspector
Mode
Exec
The following prompt is displayed in the Exec mode:
[local]host_name#
Syntax
show diameter route table [ wide ] [ endpoint endpoint_name ] [ | { grep grep_options |
more } ]
more } ]
wide
Displays the route table information in wide-format.
endpoint endpoint_name
Displays the Diameter routing table for the Diameter endpoint specified as an alphanumeric string of 1
through 63 characters.
through 63 characters.
| { grep grep_options | more }
Pipes (sends) the output of this command to a specified command. You must specify a command to which the
output of this command will be sent.
For details on the usage of
output of this command will be sent.
For details on the usage of
grep
and
more
, refer to the Regulating a Command’s Output section of the
Command Line Interface Overview chapter.
Usage
Use this command to view the status of Diameter client endpoints.
If you are in the local context, then the route information used by Diameter endpoints in all chassis contexts
will be used in the display.
The route table displays all static and dynamic routes. Refer to the route-entry CLI command in Diameter
Endpoint Configuration Mode.
Default value: N/A
If you are in the local context, then the route information used by Diameter endpoints in all chassis contexts
will be used in the display.
The route table displays all static and dynamic routes. Refer to the route-entry CLI command in Diameter
Endpoint Configuration Mode.
Default value: N/A
Example
The following command displays status of the Diameter client endpoint named
endpoint12
.
show diameter route table endpoint endpoint12