Cisco Cisco Packet Data Gateway (PDG)
Global Configuration Mode Commands (threshold poll commands A - N)
threshold poll diameter-retry-rate interval ▀
Command Line Interface Reference, StarOS Release 16 ▄
5673
threshold poll diameter-retry-rate interval
Configures the polling interval for the Diameter Credit-Control Application (DCCA) Diameter Retry Rate threshold.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold poll diameter-retry-rate interval duration
default threshold poll diameter-retry-rate interval
default
Uses the default polling interval.
Default: 300 seconds
Default: 300 seconds
interval duration
Specifies the polling interval (in seconds) for the Diameter Retry Rate threshold.
duration
must be an integer from 60 through 60000. The input will be rounded up to the closest multiple of
30.
Usage
This command specifies the polling interval for Diameter Retry Rate threshold.
Important:
All configured polling intervals are rounded up to the closest multiple of 30. For example, if a
polling interval is configured for 130 seconds, the system uses a polling interval of 150 seconds.
Refer to the
threshold monitoring
and other threshold commands in this chapter for additional
information on the system’s support for thresholding.
Important:
To enable an SNMP trap for monitoring this threshold use the
snmp trap enable
ThreshDiameterRetryRate
command in this mode.
Example
The following command configures the Diameter Retry Rate threshold polling interval to
600
seconds:
threshold poll diameter-retry-rate interval 600