Cisco Cisco Packet Data Gateway (PDG)

IPv6 ACL Configuration Mode Commands

▀ redirect context (by TCP/UDP packets)

▄ Command Line Interface Reference, StarOS Release 16

6534

redirect context (by TCP/UDP packets)

Used to redirect subscriber sessions based on the transmission control protocol/user datagram protocol packets sent by
the source to the mobile node or the network.

Product

All

Privilege

Security Administrator, Administrator

Mode

Exec > Global Configuration > Context Configuration > IPv6 ACL Configuration

configure > context context_name > ipv6 access-list ipv6_acl_name

Entering the above command sequence results in the following prompt:

[context_name]host_name(config-ipv6-acl)#

Syntax

redirect context context_id [ log ] { tcp | udp } { { source_address source_wildcard |
any | host source_host_address } [ eq source_port | gt source_port | lt source_port | neq
source_port ] } { { dest_address dest_wildcard | any | host dest_host_address } [ eq
dest_port | gt dest_port | lt dest_port | neq dst_port ] }

after redirect context context_id [ log ] { tcp | udp } { { source_address
source_wildcard | any | host source_host_address } [ eq source_port | gt source_port | lt
source_port | neq source_port ] } { { dest_address dest_wildcard | any | host
dest_host_address } [ eq dest_port | gt dest_port | lt dest_port | neq dst_port ] }

before redirect context context_id [ log ] { tcp | udp } { { source_address
source_wildcard | any | host source_host_address } [ eq source_port | gt source_port | lt
source_port | neq source_port ] } { { dest_address dest_wildcard | any | host
dest_host_address } [ eq dest_port | gt dest_port | lt dest_port | neq dst_port ] }

no redirect context context_id [ log ] { tcp | udp } { { source_address source_wildcard |
any | host source_host_address } [ eq source_port | gt source_port | lt source_port | neq
source_port ] } { { dest_address dest_wildcard | any | host dest_host_address } [ eq
dest_port | gt dest_port | lt dest_port | neq dst_port ] }

after

Indicates all rules defined subsequent to this command are to be inserted after the command identified by the
exact options listed.
This moves the insertion point to be immediately after the rule which matches the exact options specified
such that new rules will be added, in order, after the matching rule.

Important:

If the options specified do not exactly match an existing rule, the insertion point does not change.