Cisco Cisco Packet Data Gateway (PDG)
ACS Rulebase Configuration Mode Commands
ip reset-tos ▀
Command Line Interface Reference, StarOS Release 16 ▄
721
ip reset-tos
This command allows you to reset the IP Type of Service (ToS) value of incoming packets to the default QCI value,
before proceeding with the rest of ACS processing.
before proceeding with the rest of ACS processing.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Rulebase Configuration
active-charging service service_name > rulebase rulebase_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-rule-base)#
Syntax
[ default | no ] ip reset-tos
default
Configures this command with its default setting.
Default: Disabled
Default: Disabled
no
If previously configured, deletes the IP reset-tos configuration from the current rulebase.
Usage
Use this command to reset the ToS field of any packet after it reaches ACS, or to broaden the range of values
that are used in the ToS field in the IP header of any packet.
that are used in the ToS field in the IP header of any packet.