Cisco Cisco Packet Data Gateway (PDG)
Service Redundancy Protocol Configuration Mode Commands
▀ checkpoint session
▄ Command Line Interface Reference, StarOS Release 16
8194
checkpoint session
Configures checkpointing parameters between ICSR active and standby chassis.
Product
All products supporting ICSR
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > Service Redundancy Protocol Configuration
configure > context context_name > service-redundancy-protocol
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-srp)#
Syntax
checkpoint session duration seconds
default checkpoint session duration { ims-session | non-ims-session }
default
Resets the following checkpoint session parameters to their default values:
Usage
Sets the amount of time the chassis waits before check pointing an existing call session.
Configures the interval between the sending of macro-checkpoints (full checkpoints) between the active and
standby chassis.
For additional information on ICSR checkpointing, see the System Administration Guide.
Configures the interval between the sending of macro-checkpoints (full checkpoints) between the active and
standby chassis.
For additional information on ICSR checkpointing, see the System Administration Guide.
Example
The following example configures sets the checkpoint session duration to 6500 seconds:
checkpoint session duration 6500