Cisco Cisco Packet Data Gateway (PDG)
SGSN Global Configuration Mode Commands
▀ ran-information-management
▄ Command Line Interface Reference, StarOS Release 16
8272
ran-information-management
Enable/disable RAN information management (RIM) support for the SGSN.
Product
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > SGSN Global Configuration
configure > sgsn-global
Entering the above command sequence results in the following prompt:
[local]host_name(config-sgsn-global)#
Syntax
[ default | no ] ran-information-management
default
Resets the default so RIM is disabled.
no
Disables the RIM support in the configuration file.
Usage
By default, handling of RAN information management (RIM) messages is disabled. This command enables
the SGSN to handle RIM messages. When this command is enabled and RIM message handling is enabled on
the destination node, then RIM PDUs will be forwarded to the BSC/RNC. If RIM message handling is not
enabled on both nodes, then the RIM PDUs will be dropped silently.
Confirm RIM configuration with the
the SGSN to handle RIM messages. When this command is enabled and RIM message handling is enabled on
the destination node, then RIM PDUs will be forwarded to the BSC/RNC. If RIM message handling is not
enabled on both nodes, then the RIM PDUs will be dropped silently.
Confirm RIM configuration with the
show sgsn-mode
command in the Exec mode.
Example
Use the following command to enable RIM support:
ran-information-management
Use the following command to disable RIM support that has been added to the configuration:
no ran-information-management