Cisco Cisco Packet Data Gateway (PDG)

 

Configure the GPRS Tunneling Protocol Control (GTP-C) settings for the SGTP service. 

 

eWAG 

MME 

PDG/TTG 

SGSN 

 

Security Administrator, Administrator 

 

Exec > Global Configuration > Context Configuration > SGTP Service Configuration 

configure > context context_name > sgtp-service service_name

 

Entering the above command sequence results in the following prompt: 

[context_name]host_name(config-sgtp-service)# 

 

gtpc { bind address ipv4_address | dns-sgsn context context_name | echo-interval 
interval_seconds | echo-retransmission { exponential-backoff [ [ min-timeout 
timeout_seconds ] [ smooth-factor smooth_factor ] + ] | timeout timeout_seconds } | 
guard-interval interval_seconds | ignore response-port-validation | ip qos-dscp 
dscp_marking | max-retransmissions max_retransmissions | retransmission-timeout 
timeout_seconds | send { common flags | rab-context | target-identification-preamble } | 
sync-echo-with-peer } 

no gtpc { bind address | dns-sgsn context | echo-interval | send { common-flags | rab-
context | target-identification-preamble } | sync-echo-with-peer } 

default gtpc { echo-interval | echo-retransmission | guard-interval | ignore response-
port-validation | ip qos-dscp | max-retransmissions | retransmission-timeout | send { 
common-flags | rab-context | target-identification-preamble } | sync-echo-with-peer } 

 

Disables the configured GTP-C setting. 

 

Resets the specified parameter to its default value. 

bind address ipv4_address

 

Binds SGTP service to the IP address of the interface.  
The bind address for the 

 and 

 commands should be the same. 

 must be a standard IPv4 address.