Cisco Cisco Tunnel Terminating Gateway (TTG)
SGTP Service Configuration Mode Commands
pool ▀
Command Line Interface Reference, StarOS Release 16 ▄
8395
pool
This command enables the default SGSN functionality for (flex) pooling and enables inclusion of the configured pool
hop-counter count in new SGSN context/identify request messages.
hop-counter count in new SGSN context/identify request messages.
Product
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > SGTP Service Configuration
configure > context context_name > sgtp-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-sgtp-service)#
Syntax
pool { default-sgsn | hop-counter count }
no pool { default-sgsn | hop-counter }
default pool hop-counter
no
Disables the default SGSN pooling functionality or removes the SGSN pool hop-counter IE from the GTP
Identity/context requests.
Identity/context requests.
default
Removes the SGSN pool hop-counter IE from the GTP Identity/context requests.
default-sgsn
Enables default SGSN pooling functionality.
hop-counter
count
Enables and configures the SGSN pool hop-counter to set the number of hops and to include the configured
count in the new SGSN Context Requests or the new SGSN Identify Requests.
If
count in the new SGSN Context Requests or the new SGSN Identify Requests.
If
default-sgsn
is enabled, then any messages relayed will have the default value of 4 for the counter if the
message does not include this hop-counter ID.
count:
Enter an integer from 1 to 255.
Default: 4
Usage
Use this command to enable the default flex functionality without exposing the pool (flex) structure. This
functionality provides a means for SGSNs outside of the pool to reach a pooled SGSN on the basis of its NRI.
Once the pooling has been enabled. Repeat the command using the
functionality provides a means for SGSNs outside of the pool to reach a pooled SGSN on the basis of its NRI.
Once the pooling has been enabled. Repeat the command using the
hop-counter
keyword to enable
inclusion of the hop-counter IE in SGSN context/identify request messages and to configure the count for the