Cisco Cisco Packet Data Gateway (PDG)
GTPP Interface Configuration
▀ Configuring the GPRS Tunneling Protocol
▄ GTPP Interface Administration and Reference, StarOS Release 18
60
Command
Default
Comment
egcdr threshold
volume { downlink |
uplink | total
<bytes> }
volume { downlink |
uplink | total
<bytes> }
No
Specifies the downlink, uplink, and total volumes that must be met before closing
an accounting record.
an accounting record.
downlink bytes
is measured in octets and can be configured to any
integer value from 100,000 to 4,000,000,000.
uplink bytes
is measured in octets and can be configured to any
integer value from 100,000 to 4,000,000,000.
total bytes
is the total traffic volume (up and downlink) measured in
octets and can be configured to any integer value from 100,000 to
4,000,000,000.
4,000,000,000.
egcdr tariff minute
<mins> hour <hours>
<mins> hour <hours>
no egcdr tariff
<mins> hour <hours>
<mins> hour <hours>
No
Specifies the time-of-day time values for closing the current traffic volume
container (but not necessarily the accounting record). Six different tariff times
may be specified. If less than four times are required, the same time can be
specified multiple times.
container (but not necessarily the accounting record). Six different tariff times
may be specified. If less than four times are required, the same time can be
specified multiple times.
Cc profile configuration
cc profile index
[0..15] serving-nodes
[1..15]
[0..15] serving-nodes
[1..15]
index=8
serving-
nodes=4
serving-
nodes=4
Specifies the number of serving node changes for which a new address is added
to the list of serving node addresses in the CDR. A partial CDR is generated
when this limit is exceeded. Currently this is not supported.
to the list of serving node addresses in the CDR. A partial CDR is generated
when this limit is exceeded. Currently this is not supported.
Configuring GTPP for PDG and TTG
This section provides the GTPP configuration for PDG.
1. At the APN level configure GTPP in the accounting-mode.
configure
context dest1
apn apn_name
accounting-mode gtpp
gtpp group group1 accounting-context pdg
end
2. At the context level configure the accounting policy. This is required only for time/tariff/volume threshold
configuration.
configure
context dest1
policy accounting acct1
cc profile 1 interval 60