Cisco Cisco Packet Data Gateway (PDG)
• MVG Enhancements
• NAT Enhancements
• SNMP MIB Enhancements
• System and Platform Enhancements
Encode Calling Party Address in SCCP Message
CSCuy36163 - SCCP Connection Refused
Feature Changes
Previous Behavior: In earlier releases, when HNB-GW forwards an empty calling party address in the SCCP
Connection Request message to third-party vendor's MSS, it results in SCCP Connection Refused messages.
Connection Request message to third-party vendor's MSS, it results in SCCP Connection Refused messages.
New Behavior: With this release, a new CLI is introduced under the HNB-CS and HNB-PS Network
Configuration Modes to enable or disable the inclusion of the calling party address in the outgoing SCCP
Connection Request message.
Configuration Modes to enable or disable the inclusion of the calling party address in the outgoing SCCP
Connection Request message.
Command Changes
sccp (HNB-CS Network Configuration Mode)
With this release, the sccp calling-party-address command is introduced under the HNB-CS Network
Configuration Mode to enable HNB-GW to include the optional calling party address in the outgoing Signaling
Connection Control Part (SCCP) Connection Request (CR) message on the circuit switched network.
Configuration Mode to enable HNB-GW to include the optional calling party address in the outgoing Signaling
Connection Control Part (SCCP) Connection Request (CR) message on the circuit switched network.
configure
cs-network cs_instance
[ default | no ] sccp calling-party-address
end
end
Notes:
• Use the default keyword to restore the configuration to its default setting.
• If previously enabled, use the no keyword to remove the configuration and restore to the default setting.
• By default, the calling party address is not included in the outgoing SCCP CR messages.
sccp (HNB-PS Network Configuration Mode)
With this release, the sccp calling-party-address command is introduced under the HNB-PS Network
Configuration Mode to enable HNB-GW to include the optional calling party address in the outgoing Signaling
Connection Control Part (SCCP) Connection Request (CR) message on the packet switched network.
Configuration Mode to enable HNB-GW to include the optional calling party address in the outgoing Signaling
Connection Control Part (SCCP) Connection Request (CR) message on the packet switched network.
configure
ps-network ps_instance
[ default | no ] sccp calling-party-address
end
end
Notes:
Release Change Reference, StarOS Release 19
132
HNBGW Changes in Release 19
Encode Calling Party Address in SCCP Message