Cisco Cisco Packet Data Gateway (PDG)
GTPP Changes in Release 17
GTPP Enhancements for 17.0 ▀
Release Change Reference, StarOS Release 17 ▄
201
configure
context context_name
apn apn_name
accounting-mode radius
default accounting-mode
end
Notes:
The existing keyword “
radius-diameter
” is concealed to support backward compatibility.
CSCul26544 - Incorrect pdpType for a ipv4v6 call in GCDR
Applicable Products: GGSN
Feature Changes
PDPType for IPv4v6 Calls
Previous Behavior: For an IPv4v6 call, G-CDR showed value of pdpType as IPv4v6 only if the CLI command “
gtpp
attribute served-pdp-pdn-address-extn
” is enabled. If this CLI is not configured, G-CDR showed the value
as IPv6 even though it was an IPv4v6 call.
New Behavior: For an IPv4v6 call, G-CDR shows the value of pdpType as IPv4v6 irrespective of the CLI being
configured or not.
configured or not.
Customer Impact: pdpType in G-CDR will be ipv4v6 if it is an ipv4v6 call.
CSCum25831 - PI: Accounting mode GTPP and gtpp group config should be
shown in apn
Applicable Products: GGSN, P-GW
Feature Changes
CLI Display Modification
The default configuration of accounting mode in APN is “
accounting-mode gtpp
”. When “
show configuration
”
is executed, if it is a default configuration, then the default value will not be displayed. As part of this enhancement, the
accounting mode will always be displayed even if it is a default mode.
accounting mode will always be displayed even if it is a default mode.
Previous Behavior: The default value of “
accounting-mode gtpp
” was not displayed in the “
show
configuration
” command. The value was only displayed in the output of “
show configuration verbose
”
command.