Cisco Cisco Packet Data Gateway (PDG)
SecGW Changes in Release 17
SecGW Enhancements for 17.0 ▀
Release Change Reference, StarOS Release 17 ▄
459
configure
context context_name
ip rri-route network-mode { L2 | L3 } { clear_loopback_ip | rri-ip
virtual_ip_address } { ip_address | next-hop nexthop_address } interface interface_name [
vrf vrf_name ]
virtual_ip_address } { ip_address | next-hop nexthop_address } interface interface_name [
vrf vrf_name ]
end
Notes:
ip_address,
virtual_ip_address
and nexthop_address can be specified in IPv4 dotted-decimal or IPv6
colon-separated-hexadecimal format.
The next hop IP address is not required for point-to-point and tunnel interfaces.
interface_name specifies the egress interface.
ip sri-route
This Context Configuration mode command configures L3 High Availability Service Route Injection parameters:
configure
context context_name
ip sri-route sri-ip network_address next hop nexthop_address interface
interface_name [ vrf vrf_name ]
interface_name [ vrf vrf_name ]
end
Notes:
network_address and nexthop_address are specified in IPv4 dotted-decimal notation.
The next hop IP address is not required for point-to-point and tunnel interfaces.
interface_name specifies the egress interface.
rri-mode
This ConnectedApps Configuration mode CLI command configures the supported RRI mode.
configure
connectedapps
rri-mode { both | none | ras | s2s }
end
Notes:
ras = Remote Access Service
s2s = site-to-site