Cisco Cisco Packet Data Gateway (PDG)
SecGW Changes in Release 16
SecGW Enhancements for 16.1 ▀
Release Change Reference, StarOS Release 16 ▄
451
address peer_address
exit
Notes:
Repeat the address peer_address command to add up to 1,000 peer IP addresses.
Use the no address peer_address command to remove a peer address from the peer list.
peer-list
The following CLI command sequence configures the previously created peer list for use in the WSG service.
configure
context wsg_ctxt_name
wsg-service wsg_service_name
peer-list peer_list_name
exit
Notes:
peer_list_name must have been previously configured via the Context COnfiguration mode crypto peer-list
command.
Use the no peer-list command to remove the peer-list and disable the SecGW as initiator feature.
initiator-mode-duration,responder-mode-duration
When a peer list has been configured in the WSG service, the initiator and responder mode timer intervals each default
to 10 seconds. The SecGW will wait for 10 seconds in the responder mode for a peer session initiation request before
switching to the initiator mode and waiting 10 seconds for a peer response.
to 10 seconds. The SecGW will wait for 10 seconds in the responder mode for a peer session initiation request before
switching to the initiator mode and waiting 10 seconds for a peer response.
You can change the default settings for the initiator and/or responder mode intervals using the following CLI command
sequence.
sequence.
configure
context wsg_ctxt_name
wsg-service wsg_service_name
initiator-mode-duration seconds
responder-mode-duration seconds
exit
Notes:
seconds is an integer from 5 through 250.