Cisco Cisco Packet Data Gateway (PDG) Folheto
FA Service Configuration Mode Commands
threshold reg-reply-error ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
4813
threshold reg-reply-error
Set an alarm or alert based on the number of registration reply errors per FA service.
Product
PDSN
ASN-GW
GGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > FA Service Configuration
configure > context context_name > fa-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-fa-service)#
Syntax
threshold reg-reply-error high_thresh [ clear low_thresh ]
no threshold reg-reply-error
no
Deletes the alert or alarm.
high_thresh
Default: 0
The high threshold number of registration reply errors that must be met or exceeded within the polling
interval to generate an alert or alarm.
The high threshold number of registration reply errors that must be met or exceeded within the polling
interval to generate an alert or alarm.
high_thresh
can be an integer from 0 through 100000.
Important:
You must enter a value between 1 and 100000 to trigger an alert/alarm.
clear
low_thresh
Default:0
The low threshold number of registration reply errors that must be met or exceeded within the polling interval
to clear an alert or alarm.
The low threshold number of registration reply errors that must be met or exceeded within the polling interval
to clear an alert or alarm.
low_thresh
can be an integer from 0 through 100000.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Important:
You must enter a value between 1 and 100000 to trigger an alert/alarm.