Cisco Cisco Packet Data Gateway (PDG) Folheto
GGSN Service Configuration Mode Commands
associate pgw-service ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
4935
associate pgw-service
This command enables a previously configured P-GW service to which handover will be done by the GGSN service.
The P-GW service must be configured in Context Configuration mode before using this configuration.
The P-GW service must be configured in Context Configuration mode before using this configuration.
Product
GGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > GGSN Service Configuration
configure > context context_name > ggsn-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ggsn-service)#
Syntax
associate pgw-service svc_name
no associate pgw-service
no
Removes the associated P-GW service from this GGSN service configuration.
svc_name
Identifies the name of the P-GW service preconfigured in Context Configuration mode to which handover
will be done.
The
will be done.
The
svc_name
must be an alphanumeric string from 1 through 63 characters.
Usage
Use this command to allow enabling/disabling bearer handover from GGSN to a P-GW service. The service
defined for P-GW can be configured in Context configuration mode.
The P-GW’s eGTP service should have the same bind address as GGSN service and P-GW and GGSN
should share same GTP-U, otherwise handover will fail.
defined for P-GW can be configured in Context configuration mode.
The P-GW’s eGTP service should have the same bind address as GGSN service and P-GW and GGSN
should share same GTP-U, otherwise handover will fail.
Example
Following command enables P-GW service named
pgw-test
handover with specific GGSN service.
associate pgw-service pgw-test