Cisco Cisco Packet Data Gateway (PDG) Folheto
Global Configuration Mode Commands (T-threshold phspc)
threshold asnpc-im-entry-denial ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
5319
threshold asnpc-im-entry-denial
Configures the ASNPC Instant Messenger (IM) entry denial, alarm or alert thresholds.
Product
ASN-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold asnpc-im-entry-denial high_thresh [ clear low_thresh ]
high_thresh
Default: 0
Specifies the high threshold number of IM entry denials during session that must be met or exceeded within
the polling interval to generate an alert or alarm.
Specifies the high threshold number of IM entry denials during session that must be met or exceeded within
the polling interval to generate an alert or alarm.
high_thresh
is an integer from 0 through 10000000. A value of 0 disables the threshold.
clear
low_thresh
Default: 0
Specifies the low threshold number of IM entry denials during session that maintains a previously generated
alarm condition. If the number of session timeouts falls beneath the low threshold within the polling interval,
a clear alarm will be generated.
Specifies the low threshold number of IM entry denials during session that maintains a previously generated
alarm condition. If the number of session timeouts falls beneath the low threshold within the polling interval,
a clear alarm will be generated.
low_thresh
is an integer from 0 through 10000000. A value of 0 disables the threshold.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
Set the maximum number of IM session denials allowed in the ASNPC service.
Alerts or alarms are triggered for session timeouts based on the following rules:
Alerts or alarms are triggered for session timeouts based on the following rules:
Enter condition: Actual number of failures is greater than or equal to the high threshold.
Clear condition: Actual number of failures is less than the low threshold.
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end
of the polling interval.
Refer to the
of the polling interval.
Refer to the
threshold poll
command to configure the polling interval and the
threshold monitoring
command to enable thresholding for this value.
Example
The following command configures the high threshold for IM session counts at
10000
: