Cisco Cisco Packet Data Gateway (PDG) Folheto
Global Configuration Mode Commands (threshold poll commands A - N)
threshold poll dcca-rating-failed interval ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
5513
threshold poll dcca-rating-failed interval
Configures the polling interval for Diameter Credit-Control Application (DCCA) Rating Failed threshold.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold poll dcca-rating-failed interval duration
default threshold poll dcca-rating-failed interval
default
Uses the default polling interval.
Default: 900 seconds
Default: 900 seconds
interval duration
Specifies the polling interval (in seconds) for the DCCA Rating Failed threshold.
duration
must be an integer from 60 through 60000.
Usage
This command configures the polling interval for DCCA Rating Failed threshold.
Important:
All configured polling intervals are rounded up to the closest multiple of 30. For example, if a
polling interval is configured for 130 seconds, the system uses a polling interval of 150 seconds.
Refer to the
threshold monitoring
and other threshold commands for additional information on the
system’s support for thresholding in this chapter.
Important:
To enable an SNMP trap for monitoring this threshold use the
snmp trap enable
ThreshDCCARatingFailed
command in this mode.
Example
The following command configures the polling interval to
600
seconds for the Diameter Credit Control
Application (DCCA) Rating Group (content-id) request reject thresholds:
threshold poll dcca-rating-failed interval 600