Cisco Cisco Packet Data Gateway (PDG) Folheto
HNB-PS Network Configuration Mode Commands
sgsn point-code ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
6161
sgsn point-code
Configures the default SGSN point-code with the HNB-PS network instance. This command is used when HNB-GW is
to be connected to only one SGSN with in a PS network or as the default SGSN for all HNBs connected through
specific HNB-PS network instance.
to be connected to only one SGSN with in a PS network or as the default SGSN for all HNBs connected through
specific HNB-PS network instance.
Product
HNB-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > HNB-PS Network Configuration
configure > ps-network ps_instance
Entering the above command sequence results in the following prompt:
[local]host_name(config-ps-network-instance_id)#
Syntax
[ no ] sgsn point-code point_code
no
Removes the configured default SGSN point code from specific HNB-PS network instance.
Caution:
Removing the SGSN point code is a disruptive operation and affects all HNB sessions which are
connected to particular SGSN through an HNB-PS network instance.
point_code
Specifies the SS7 address of the default SGSN in a PS network.
point_code
is ann SS7 point code in dotted-decimal ###.###.### or 8-digit decimal ######## format.
Only one instance of this command can be configured.
Usage
Use this command to configure a default SGSN to which HNB connects for PS network access through the
HNB-GW service.
Point-code is an SS7 address for an element in the SS7 network. Point-codes must be defined in dotted-
decimal format in a string of 1 to 11 digits. Format options include:
HNB-GW service.
Point-code is an SS7 address for an element in the SS7 network. Point-codes must be defined in dotted-
decimal format in a string of 1 to 11 digits. Format options include:
0.0.1 to 7.255.7 for point-code in the ITU range.
0.0.1 to 255.255.255 for point-code in the ANSI range.
0.0.1 to 15.31.255 for point-code in the TTC Range.
a string of 1 to 11 digits in dotted-decimal to represent a point-code in a different range.
Important:
This command can be entered only once. If entered again the previous value shall be overwritten.
Example