Cisco Cisco Packet Data Gateway (PDG) Folheto
IMEI Profile Configuration Mode
direct-tunnel ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
6215
direct-tunnel
Instruct the SGSN to enable/disable a direct tunnel between the RNC and the GGSN based on the IuPS service
configuration.
configuration.
Product
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > IMEI Profile Configuration
configure > imei-profile profile_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-imei-profile-profile_name)#
Syntax
direct-tunnel check-iups-service
no direct-tunnel
no direct-tunnel
This command instructs the SGSN to disable the direct tunnel function between the GGSN and the RNC.
Usage
Direct tunnel is enabled by default on the GGSN and often on the RNC. This leaves it to the SGSN’s
configuration to actually enable or disable a direct tunnel.
With the SGSN, the options for configuring a direct tunnel are complex -- enable/disable on the basis of
APNs, or RNCs, or GGSNs, or on the basis of the IMEI range. Refer to the SGSN Administration Guide for
configuration details.
configuration to actually enable or disable a direct tunnel.
With the SGSN, the options for configuring a direct tunnel are complex -- enable/disable on the basis of
APNs, or RNCs, or GGSNs, or on the basis of the IMEI range. Refer to the SGSN Administration Guide for
configuration details.
Example
Assuming the IuPS service configuration has enabled DT for associated RNCs, then use this command to
enable DT from the RNC to the GGSN associated with this IMEI profile:
enable DT from the RNC to the GGSN associated with this IMEI profile:
direct tunnel check-iups-service