Cisco Cisco Packet Data Gateway (PDG)
Statistics and Counters Reference, StarOS Release 16 ▄
4395
show linecard
This chapter describes the outputs of the
show linecard
command.
show linecard table
Table 395.
show linecard table
Command Output Descriptions
Field
Description
Slot
Displays the chassis slot number and type. The slot type represents the type of card(s) that the slot
supports. Possible slot types are: Ethernet 10/100, Ethernet 1000 line card, four-port Quad Gig-E
(QGLC) line card (ASR 5000 only), and the10 Gigabit Ethernet Line Card (XGLC) *
Possible slot numbers are: 17 through 23, 26 through 39, and slots 42 through 48
*The XGLC is a full-length line card. It only fits in upper slots 17 through 23 and 26 through 32. Slots
24 and 25 would support the Switch Processor Input/Output (SPIO) card associated for the XGLC.
supports. Possible slot types are: Ethernet 10/100, Ethernet 1000 line card, four-port Quad Gig-E
(QGLC) line card (ASR 5000 only), and the10 Gigabit Ethernet Line Card (XGLC) *
Possible slot numbers are: 17 through 23, 26 through 39, and slots 42 through 48
*The XGLC is a full-length line card. It only fits in upper slots 17 through 23 and 26 through 32. Slots
24 and 25 would support the Switch Processor Input/Output (SPIO) card associated for the XGLC.
Card
Type
Type
Displays the type of card installed. The possible card types supported for this release are: Ethernet
10/100 Line Card, Ethernet 1000 Line Card (QGLC), 10 Gig Ethernet Line Card (XGLC), Switch
Processor Input/Output Card.
10/100 Line Card, Ethernet 1000 Line Card (QGLC), 10 Gig Ethernet Line Card (XGLC), Switch
Processor Input/Output Card.
# Ports
Displays the maximum number of physical ports supported per card.
The Ethernet 10/100 Line Card supports 8 ports.
The Ethernet 1000 Line Card supports 1 port.
The Quad Gig-E (QGLC) Line Card supports 4 ports
The 10 Gig Ethernet Line Card (XGLC) supports 1 port
The Switch Processor Input/Output Card supports 2 ports.
Oper
State
State
Displays the operational state of the card. The possible operational states are:
Active: Indicates that the card is an active component that will be used to process subscriber
data sessions.
data sessions.
Standby: Indicates that the card is a redundant component. Redundant components will
become active through manual configuration or automatically should a failure occur.
become active through manual configuration or automatically should a failure occur.
Offline: Indicates that the card is installed but is not ready to process subscriber data sessions.
This could be due to the fact that it is not completely installed (i.e. the card interlock switch is
not locked, refer to the System Installation Guide for information on installing cards in the
system) or that its processes have been halted.
This could be due to the fact that it is not completely installed (i.e. the card interlock switch is
not locked, refer to the System Installation Guide for information on installing cards in the
system) or that its processes have been halted.
SPOF
Displays whether or not the component is a single point of failure (SPOF) in the system. If the
component is an SPOF, then a Yes will appear in this column. If not, a No will be displayed.
component is an SPOF, then a Yes will appear in this column. If not, a No will be displayed.