Cisco Cisco Packet Data Gateway (PDG)

 

         remotefile format naming_convention [ both-receivers | primary-receiver 
| secondary-receiver ] 

         header format header_format 

         footer format footer_format 

         exit 

      name schema format format_string 

      sample-interval time_interval 

      transfer-interval xmit_time_interval 

      limit mem_limit 

      exit 

   bulkstats collection 

   end 

In each configuration example described in Configuring Standard Settings and Configuring Optional Settings, the 
following is the primary command used to configure the type of schema and the statistics collected: 

name schema format format_string 

Refer to the Bulk Statistics Configuration Mode Commands and Bulk Statistics File Configuration Mode Commands 
chapters in the Command Line Interface Reference for more information regarding supported schemas, available 
statistics, and proper command syntax. 

After configuring support for bulk statistics on the system, you can check your settings prior to saving them. 

Follow the instructions in this section to verify your bulk statistic settings. These instructions assume that you are at the 
root prompt for the Exec mode. 

Check your collection server communication and schema settings by entering the following command: 

show bulkstats schemas 

The following is an example command output: 

Bulk Statistics Server Configuration: 

  Server State:                 Enabled  

  File Limit:                   6000 KB  

  Sample Interval:              15 minutes (0D 0H 15M)