Cisco Cisco Packet Data Gateway (PDG)
Session Recovery
Configuring VPC-VSM to Support Session Recovery ▀
VPC-VSM System Administration Guide, StarOS Release 19 ▄
243
Important:
If this command is issued on an in-service instance, StarOS must be restarted by issuing the reload
command.
Viewing Session Recovery Status
To determine if a VPC-VSM instance is capable of performing session recovery, when enabled, enter the show session
recovery status verbose command from the StarOS CLI Exec mode prompt.
recovery status verbose command from the StarOS CLI Exec mode prompt.
The output of this command should be similar to the examples shown below.
[local]host_name# show session recovery status
Session Recovery Status:
Overall Status : SESSMGR Not Ready For Recovery
Last Status Update : 1 second ago
[local]host_name# show session recovery status
Session Recovery Status:
Overall Status : Ready For Recovery
Last Status Update : 8 seconds ago
[local]host_name# show session recovery status verbose
Session Recovery Status:
Overall Status : Ready For Recovery
Last Status Update : 2 seconds ago
----sessmgr--- ----aaamgr---- demux
cpu state active standby active standby active status
---- ------- ------ ------- ------ ------- ------ ------------
1/1 Active 2 1 1 1 0 Good
1/2 Active 1 1 0 0 0 Good
1/3 Active 1 1 3 1 0 Good
1/4 Active 1 1 4 1 0 Good