Cisco Cisco Packet Data Gateway (PDG)
Engineering Rules
▀ Subscriber Rules
▄ VPC-VSM System Administration Guide, StarOS Release 19
300
Subscriber Rules
The following engineering rules apply to subscribers configured within the system:
Configure a maximum of 2,048 local subscribers per context.
You may configure attributes for each local subscriber.
VPC creates a default subscriber for each context when the context is made. Configure attributes for each default
subscriber. If a AAA-based subscriber is missing attributes in the authentication reply message, the default
subscriber attributes in the context where the subscriber was authenticated are used.
subscriber attributes in the context where the subscriber was authenticated are used.
Important:
Default is not used when local authentication (for local subscribers) is performed.
Configure default subscriber templates on a per AAA realm (domain aliases configured within a context) basis.
Configure default subscriber templates on a per PDSN, FA, or HA service.
For AAA authenticated subscribers, the selection of local subscriber template to use for setting attributes is in the
following order:
If the username (NAI) matches any local domain name and the domain name has a local subscriber
name configured, that local subscriber template is used.
If the first case fails, and if the serving service has a default username configured, that subscriber
template is used.
If the first two cases fail, the default subscriber template in the AAA context is used.