Cisco Cisco Packet Data Gateway (PDG)

 

v 

remote           local      st poll reach  delay   offset    disp 

======================================================================= 

*10.0.4.5        0.0.0.0          3   64    1 0.00060  0.000019 0.00029 

*10.0.4.5        0.0.0.0          3   64    1 0.00060  0.000019 0.00029 

To display a timestamp (date and time) for every command that is executed on the CLI, enter the following command at 
the root prompt for the Exec mode: 

timestamps 

The date and time appear immediately after you execute the command. 

Save the configuration as described in the Verifying and Saving Your Configuration chapter. 

Getting Started describes how to configure a StarOS context-level security administrator. 

This section provides instructions for configuring additional administrative users having the following privileges: 



 

Security Administrators: have read-write privileges and can execute all CLI commands, including those 

available to Administrators, Operators, and Inspectors 



 

Administrators: have read-write privileges and can execute any command in the CLI except for a few security-

related commands that can only be configured by Security Administrators. Administrators can configure or 
modify system settings and execute all system commands, including those available to the Operators and 
Inspectors. 



 

Operators: have read-only privileges to a larger subset of the Exec Mode commands. They can execute all 

commands that are part of the inspector mode, plus some system monitoring, statistic, and fault management 
functions. Operators do not have the ability to enter the Config Mode. 



 

Inspectors: are limited to a few read-only Exec Mode commands. The bulk of these are show commands for 

viewing a variety of statistics and conditions. An Inspector cannot execute show configuration commands and 
does not have the privilege to enter the Config Mode. 

Configuration instructions are categorized according to the type of administrative user: context-level or local-user. 

  For information on the differences between these user privileges and types, refer to the Getting 

Started chapter. 

This section contains information and instructions for configuring context-level administrative user types.