Cisco Cisco Packet Data Gateway (PDG)
Verifying and Saving Your Configuration
▀ Verifying the Configuration
▄ VPC-VSM System Administration Guide, StarOS Release 19
76
Verifying the Configuration
You can use a number of commands to verify the configuration of your feature, service, or system. Many are
hierarchical in their implementation and some are specific to portions of or specific lines in the configuration file.
hierarchical in their implementation and some are specific to portions of or specific lines in the configuration file.
Important:
Each VPC-VSM instance (StarOS VM) is separately configured on a VSM (four VMs per VSM).
You must separately configure and save each instance.
Feature Configuration
In many configurations, you have to set and verify specific features. An example includes IP address pool configuration.
Using the example below, enter the listed commands to verify proper feature configuration.
Using the example below, enter the listed commands to verify proper feature configuration.
Enter the show connectedapps command to display the StarOS oneP session configuration. The output from this
command should look similar to the sample shown below.
command should look similar to the sample shown below.
Current connectedapps controller configuration:
CA session usedid : vsm01
CA session password : cisco123
CA session name : wsg
CA session IP address : 30.30.30.13
RRI mode : ENABLED
HA chassis mode : inter
HA network mode : L3
CA session Activation : YES
CA session ID : 0
CA SRP Status : INIT
CA SRP State : INIT
Important:
To configure features on the system, use the show commands specifically for these features. Refer to
the Exec Mode show Commands chapter in the Command Line Interface Reference for more information.