Cisco Cisco Packet Data Gateway (PDG) Guia Do Administrador
Interchassis Session Recovery
▀ Configuring Interchassis Session Recovery (ICSR)
▄ Cisco ASR 5500 System Administration Guide
300
Configuring the SRP Context Interface Parameters
This procedure configures the communication interface with the IP address and port number within the SRP context.
This interface supports interchassis communication.
This interface supports interchassis communication.
Important:
CLI commands must be executed on both chassis. Log onto both chassis before continuing. Always
make configuration changes on the primary chassis first.
configure
context vpn_ctxt_name [-noconfirm]
interface srp_if_name
ip-address { ip_address | ip_address/mask }
exit
exit
port ethernet slot_num/port_num
description des_string
medium { auto | speed { 10 | 100 | 1000 } duplex { full | half } }
no shutdown
bind interface srp_if_name srp_ctxt_name
end
Verifying SRP Configuration
Step 1
Verify that your SRP contexts were created and configured properly by entering the show srp info command (Exec
Mode).
Mode).
Sample output for this command as shown. In this example, an SRP context called srp1 was configured with default
parameters.
parameters.
Service Redundancy Protocol:
----------------------------------------------------------------------
Context: srp1
Local Address: 0.0.0.0
Chassis State: Init
Chassis Mode: Backup
Chassis Priority: 125
Local Tiebreaker: 00-00-00-00-00-00
Route-Modifier: 34
Peer Remote Address: 0.0.0.0
Peer State: Init
Peer Mode: Init
----------------------------------------------------------------------
Context: srp1
Local Address: 0.0.0.0
Chassis State: Init
Chassis Mode: Backup
Chassis Priority: 125
Local Tiebreaker: 00-00-00-00-00-00
Route-Modifier: 34
Peer Remote Address: 0.0.0.0
Peer State: Init
Peer Mode: Init