Cisco Cisco Packet Data Gateway (PDG) Nota De Lançamento
ECS Changes in Release 15.0
▀ ECS Enhancements for October 31, 2014
▄ Cisco ASR 5x00 Release Change Reference
142
Total Sessions with Charging-Updates Active Bandwidth Limit: 0
CSCup67356 - Rule failure counters not incremented
Applicable Products: GGSN, HA, HSGW, IPSG, PDSN, P-GW, SAEGW
Feature Changes
Counter for ACS Reject Reason in No Active Rule Condition
Previous Behavior: The subscriber call was rejected when there was no active rule in the rulebase. In this scenario,
there was no counter to indicate the corresponding reason for the call rejection through the CLI command “
there was no counter to indicate the corresponding reason for the call rejection through the CLI command “
show
active-charging service statistics
”.
New Behavior: Now, the “
show active-charging service statistics
” CLI command will indicate the total
number of ACS calls rejected due to no active rule.
Performance Indicator Changes
show active-charging service statistics
The following new counter has been added to the output of
show active-charging service statistics
command to report the number of ACS calls that were rejected due to no active rule.
No active rule in Rulebase/Subs
CSCuq15304 - Out-Of-Order timeout expires unexpectedly leading to misbilling
Applicable Products: GGSN, HSGW, PDSN, P-GW, SAEGW
Feature Changes
Change in ‘Out-Of-Order Timeout’ Functionality
Previous Behavior: Earlier, when using active-charging and ruledefs to differentiate billing for different flows, for
some flows which contained a lot of out-of-order packets (and retransmitted packets), the OOO timeout might fire
unexpectedly; the TCP in-order packets were forwarded and TCP OOO timeout was still being run.
some flows which contained a lot of out-of-order packets (and retransmitted packets), the OOO timeout might fire
unexpectedly; the TCP in-order packets were forwarded and TCP OOO timeout was still being run.
New Behavior: Now, when the TCP in-order packets are received, the list is checked for any pending packets. If there
are any pending packets in the list, the timer is extended so that packet in list can get configured time for reordering.
are any pending packets in the list, the timer is extended so that packet in list can get configured time for reordering.