Cisco Cisco Packet Data Gateway (PDG) Nota De Lançamento
GGSN Changes in Release 15.0
GGSN Enhancements for November 30, 2013 ▀
Cisco ASR 5x00 Release Change Reference ▄
207
It is a new command added to set the default behavior as Best Effort using a zero value in the 3-bit MPLS EXP
(Experimental) header. This setting overrides the value sent by the mobile subscriber.
(Experimental) header. This setting overrides the value sent by the mobile subscriber.
configure
context context_name
[ no ] mpls exp <value>
end
Notes:
<value>
Specifies the MPLS EXP header value as an integer from 0 through 7. Higher value indicates higher priority.
no
Reverts back to the default behavior, which is to copy the DSCP from the mobile subscriber packet to the EXP
header of the packet, if there is no explicit configuration for DSCP to EXP.
header of the packet, if there is no explicit configuration for DSCP to EXP.
CSCuh73686 - GGSN: Modification of ‘timeout bearer-inactivity’ CLI to ignore
default bearer
Feature Changes
Timeout Bearer Inactivity Feature
Previous Behavior: The timeout bearer-inactivity CLI monitored all bearers on the PDN for inactivity. If the default
bearer timed out unexpectedly, it caused the session to be torn down and the user was disconnected. This feature also
looked at both uplink and downlink data.
bearer timed out unexpectedly, it caused the session to be torn down and the user was disconnected. This feature also
looked at both uplink and downlink data.
New Behavior: The bearer inactivity timer can now be configured to exclude default bearer/primary bearer from
monitoring bearer inactivity. In addition, this feature now has the option to look at either uplink or downlink data.
monitoring bearer inactivity. In addition, this feature now has the option to look at either uplink or downlink data.
Command Changes
timeout bearer-inactivity
This command configures the bearer inactivity timer and the threshold value of the traffic through an APN.
New keywords have been added so the threshold value can now be configured for monitoring traffic at various levels.
The bearer inactivity timer can also be configured to exclude default bearer/primary bearer from monitoring bearer
inactivity.
The bearer inactivity timer can also be configured to exclude default bearer/primary bearer from monitoring bearer
inactivity.
configure
context context_name
apn apn_name