Cisco Cisco Packet Data Gateway (PDG) Nota De Lançamento
System Changes in Release 15.0
▀ System and Platform Enhancements for September 30, 2013
▄ Cisco ASR 5x00 Release Change Reference
610
support collection [ sleep-duration [ hours <h> | minutes <m> ] ] [ max-records <n> ]
no support collection
default support collection
end
Notes:
The support collection command modifies and/or enables the support collection process. If support collection
has been previously disabled, this command enables the collection activity. If the support collection is currently
enabled, this command may be used to modify the sleep-duration interval and/or the maximum number of
SDRs that can be collected and stored.
enabled, this command may be used to modify the sleep-duration interval and/or the maximum number of
SDRs that can be collected and stored.
The sleep duration keyword specifies the time interval between the collection of support data. It can be
specified in hours or minutes with a default of one hour (60 minutes).
The max-records keyword specifies the number of SDRs to store as an integer from 1 to 65535. When this
value is exceeded, the new SDR overwrites the oldest SDR. The default value is 168.
support record
The support record section command configures a specific record section or set of record sections for a support
information output command. The order in which the record section commands are specified defines the order in which
the collected support data record sections are saved.
information output command. The order in which the record section commands are specified defines the order in which
the collected support data record sections are saved.
configure
support record section <section-name> command “<command-string>” [ section <section-
name> command “<command-string>” ] ...
name> command “<command-string>” ] ...
no support record [ all | section <section_name> ]
default support record [ all | section <section_name> ]
Note:
If the support record section command is not explicitly configured by the user, a default set of record section
commands are used. These default record section commands are displayed wh enden you run the show
configuration verbose command. If support record section commands are explicitly configured, they replace
the default commands.
configuration verbose command. If support record section commands are explicitly configured, they replace
the default commands.
tech-support test-commands password
Sets the password required to execute the cli test-commands command in the Exec and Global Configuration mode.
config
tech-support test-commands [encrypted] password password
no tech-support test-commands password
end