Cisco Cisco Aironet 350 Wireless LAN Client Adapter Guia De Resolução De Problemas
Cisco Aironet Client Adapter Installation Tips for
Windows NT v4.0
Windows NT v4.0
Document ID: 19057
To get Cisco Aironet drivers, firmware and utility software, use this link
to the Cisco Wireless Software Center.
to the Cisco Wireless Software Center.
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Determine Which Interrupts Are Used
Install the Drivers
Related Information
Prerequisites
Requirements
Components Used
Conventions
Determine Which Interrupts Are Used
Install the Drivers
Related Information
Introduction
The Cisco Aironet Client Adapter Installation Wizard for Windows automates the installation of the Aironet
Client Utility (ACU) and related drivers, and adjusts the system resources so the hardware can interact
appropriately with Windows. In legacy installations where that wizard is not used, you must use an alternative
installation method. The procedure to install the Cisco Aironet Client Adapter card on a Windows NT
platform is different from the installation process on other Windows platforms. This document describes the
method to set the IRQ and I/O port numbers used by the Client Adapter card.
Client Utility (ACU) and related drivers, and adjusts the system resources so the hardware can interact
appropriately with Windows. In legacy installations where that wizard is not used, you must use an alternative
installation method. The procedure to install the Cisco Aironet Client Adapter card on a Windows NT
platform is different from the installation process on other Windows platforms. This document describes the
method to set the IRQ and I/O port numbers used by the Client Adapter card.
Prerequisites
Requirements
The reader should be familiar with the Windows GUI and the Control Panel.
Components Used
This document is applicable to any platform that runs Windows NT version 4.0.
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Conventions
For more information on document conventions, refer to the Cisco Technical Tips Conventions.
Determine Which Interrupts Are Used
Since Windows NT v4.0 does not support Plug−and−Play, you must determine the available IRQ and I/O port