Cisco Cisco Aironet 350 Wireless LAN Client Adapter
9
Release Notes for Cisco Aironet Client Utilities (Version 2.30) and Drivers (Version 2.30) for Windows CE
OL-3962-01
Caveats
Step 24
Perform one of the following:
•
If your device is connected to a DHCP server, select Obtain an IP address via DHCP or
Use server-assigned IP address and tap OK.
Use server-assigned IP address and tap OK.
•
If your device is not connected to a DHCP server, select Specify an IP address or Use specific IP
address and follow the steps below:
address and follow the steps below:
a.
Enter the IP address, subnet mask, and default gateway address you want to assign to your
device. They can be obtained from your system administrator.
device. They can be obtained from your system administrator.
b.
Select the Name Servers tab and enter the primary and secondary DNS and WINS you want to
assign to your device. They can be obtained from your system administrator.
assign to your device. They can be obtained from your system administrator.
c.
Tap OK.
The driver and client utility installation is complete. To verify that you have properly installed the driver
and client utilities, check the client adapter’s LEDs. If the installation was successful, the client adapter’s
green LED blinks.
and client utilities, check the client adapter’s LEDs. If the installation was successful, the client adapter’s
green LED blinks.
Note
Refer to the Cisco Aironet Wireless LAN Client Adapters Installation and Configuration
Guide for Windows CE (version -03) for information on configuring your client adapter.
Guide for Windows CE (version -03) for information on configuring your client adapter.
Caveats
This section describes resolved and open caveats for client utility and driver release 2.30 for
Windows CE.
Windows CE.
Resolved Caveats
The following caveats are resolved in client utility and driver release 2.30 for Windows CE.
•
CSCdx73802—Client adapter driver not loading correctly on Windows CE 3.0 device
The client adapter is detected in the Windows CE 3.0 device, but the driver does not run, and the
green LED remains solid.
green LED remains solid.
•
CSCdw03461—Overlapping icons in the Cisco folder
After you install the driver and client utilities, the icons for the utilities overlap one another in the
Cisco folder.
Cisco folder.
•
CSCdx17502—Client adapter not found after Symbol device suspends and resumes
After some Symbol devices are suspended and resumed, ACU indicates that the installed client
adapter is not found. To resolve this issue, reset the Symbol device.
adapter is not found. To resolve this issue, reset the Symbol device.
•
CSCin13763—Windows CE devices fail to get an IP address
When an HP Jornada or Compaq iPAQ 3800 device with MIC and WEP enabled is turned off and
on again, it fails to get an IP address from the DHCP server.
on again, it fails to get an IP address from the DHCP server.