Cisco Cisco Aironet 350 Wireless LAN Client Adapter
8
Release Notes for Cisco Aironet Client Utilities 2.72 and Driver 2.72 for Windows CE
OL-10423-01
Installing or Upgrading to a New Client Utility and Driver Release
Step 22
If you are using a PPC 2002 device and you installed the 802.1X backport, reset your Windows CE
device now. (You should have been notified earlier that a reset would be required after installation.)
device now. (You should have been notified earlier that a reset would be required after installation.)
Step 23
Insert the client adapter into the PC card slot of the Windows CE device. The Windows CE device should
configure the client adapter, and the green LED on the adapter should blink. If this does not happen,
remove the client adapter, reset the Windows CE device, and reinsert the client adapter.
configure the client adapter, and the green LED on the adapter should blink. If this does not happen,
remove the client adapter, reset the Windows CE device, and reinsert the client adapter.
Step 24
The Cisco Wireless LAN Adapter Settings dialog box appears. If the dialog box does not appear, perform
one of the following:
one of the following:
•
Tap Start > Settings > the Connections tab > Connections > Advanced > Network Card > Cisco
Wireless LAN Adapter on PPC 2003 devices.
Wireless LAN Adapter on PPC 2003 devices.
•
Tap Start > Settings > the Connections tab > Network Adapters > Cisco Wireless LAN Adapter
> Properties on PPC 2002 devices.
> Properties on PPC 2002 devices.
•
Tap Start > Settings > Control Panel > Network > the Adapters tab > Cisco Wireless LAN
Adapter > Properties on HPC devices.
Adapter > Properties on HPC devices.
•
Tap Start > Settings > Network and Dial-up Connections > the Cisco Wireless LAN Client
Adapter icon on Windows CE .NET devices.
Adapter icon on Windows CE .NET devices.
Step 25
Perform one of the following:
•
If your device is connected to a DHCP server, choose Obtain an IP address via DHCP or
Use server-assigned IP address and tap OK.
Use server-assigned IP address and tap OK.
•
If your device is not connected to a DHCP server, choose Specify an IP address or Use specific IP
address and follow these steps:
address and follow these steps:
a.
Enter the IP address, subnet mask, and default gateway address you want to assign to your device.
They can be obtained from your system administrator.
b.
Choose the Name Servers tab and enter the primary and secondary DNS and WINS you want to
assign to your device. They can be obtained from your system administrator.
c.
Tap OK.
The driver and client utility installation is complete. To verify that you have properly installed the driver
and client utilities, check the client adapter’s LEDs. If the installation was successful, the client adapter’s
green LED blinks.
and client utilities, check the client adapter’s LEDs. If the installation was successful, the client adapter’s
green LED blinks.
Note
Refer to the Cisco Aironet 350 Series Wireless LAN Client Adapters Installation and
Configuration Guide for Windows CE (part number OL-1375-05) for information on configuring
your client adapter.
Configuration Guide for Windows CE (part number OL-1375-05) for information on configuring
your client adapter.