Cisco Cisco WAP561 Wireless-N Dual Radio Selectable Band Access Point Manual De Manutenção
Single Point Setup
Single Point Setup Overview
Cisco Small Business WAP551 and WAP561 Wireless-N Access Point
153
10
Single Point Setup allows the management of more than one cluster in the same
subnet or network; however, they are managed as single independent entities.
The table below shows Single Point Setup wireless service limits.
subnet or network; however, they are managed as single independent entities.
The table below shows Single Point Setup wireless service limits.
A cluster can propagate configuration information, such as VAP settings, QoS
queue parameters, and radio parameters. When you configure Single Point Setup
on a device, settings from that device (whether they are manually set or set by
default) are propagated to other devices as they join the cluster. To form a cluster,
make sure the following prerequisites or conditions are met:
queue parameters, and radio parameters. When you configure Single Point Setup
on a device, settings from that device (whether they are manually set or set by
default) are propagated to other devices as they join the cluster. To form a cluster,
make sure the following prerequisites or conditions are met:
STEP 1
Plan your Single Point Setup cluster. Be sure the two or more WAP devices you
want to cluster are compatible with each other. For example, Cisco WAP551
devices can only cluster with other Cisco WAP551 or WAP561 devices.
want to cluster are compatible with each other. For example, Cisco WAP551
devices can only cluster with other Cisco WAP551 or WAP561 devices.
NOTE
It is strongly recommended to run the latest firmware version on all
clustered WAP devices. Firmware upgrades are not propagated to all WAP
devices in a cluster; you must upgrade each device independently.
devices in a cluster; you must upgrade each device independently.
STEP 2
Set up the WAP devices that will be clustered on the same IP subnet and verify
that they are interconnected and accessible across the switched LAN network.
that they are interconnected and accessible across the switched LAN network.
STEP 3
Enable Single Point Setup on all WAP devices. See
.
STEP 4
Verify that the WAP devices all reference the same Single Point Setup name. See
NOTE
For two devices to be in the same Single Point Setup, they do not need to have the
same number of radios; however, the supported capabilities of the radios should
be same.
same number of radios; however, the supported capabilities of the radios should
be same.
Group/Cluster
Type
Type
WAP Devices
per Single Point
Setup
per Single Point
Setup
Number of
Active Clients
per Single Point
Setup
Active Clients
per Single Point
Setup
Maximum
Number of
Clients (Active
and Idle)
Number of
Clients (Active
and Idle)
WAP5xx
16
480
960 for the
WAP561 with a
dual radio
WAP561 with a
dual radio
1024
2048 for the
WAP561 with a
dual radio
WAP561 with a
dual radio