Cisco Cisco Prime Optical 9.6 Guia Do Programador
Cisco Prime Optical 9.6.3 GateWay/CORBA Programmer Reference Guide
OL-28047-01
210
For the ONS 15454 SONET R3.4 or later, the loopback state can be set only if the TP state is
either Out of Service–Maintenance or Auto in Service.
ONS 15600 SDH
Prime Optical supports only terminal and facility loopback operations for PTPs.
Prime Optical does not support loopback operations for CTPs.
Loopback is supported only in the Out of Service–Maintenance state of the PTP.
Prime Optical ignores the MaintenanceOperation_T value in CurrentMaintenanceOperation_T
ONS 15600 SDH
Prime Optical supports only terminal and facility loopback operations for PTPs.
Prime Optical does not support loopback operations for CTPs.
Loopback is supported only in the Out of Service–Maintenance state of the PTP.
Prime Optical ignores the MaintenanceOperation_T value in CurrentMaintenanceOperation_T
structure, if MaintenanceOperationMode_T is set to MOM_RELEASE.
ONS 15600 SONET
Prime Optical supports only facility and payload loopback operations for PTPs.
Prime Optical does not support loopback operations for CTPs.
Loopback is supported only in the Out of Service–Maintenance state of the PTP.
Prime Optical ignores the MaintenanceOperation_T value in CurrentMaintenanceOperation_T
ONS 15600 SONET
Prime Optical supports only facility and payload loopback operations for PTPs.
Prime Optical does not support loopback operations for CTPs.
Loopback is supported only in the Out of Service–Maintenance state of the PTP.
Prime Optical ignores the MaintenanceOperation_T value in CurrentMaintenanceOperation_T
structure, if MaintenanceOperationMode_T is set to MOM_RELEASE.
CPT 200, CPT 200 SDH, CPT 600, and CPT 600 SDH
Prime Optical supports only terminal and facility loopback operations for PTPs.
The loopback state can be set only if the TP state is either Out of Service–Maintenance or Auto
CPT 200, CPT 200 SDH, CPT 600, and CPT 600 SDH
Prime Optical supports only terminal and facility loopback operations for PTPs.
The loopback state can be set only if the TP state is either Out of Service–Maintenance or Auto
in Service.
Parameters
Parameters
Name
Type
Input/
Output
Description
maintenanceOperation
CurrentMaintenanceOperatio
n_T
In
Information on the maintenance
operation to perform. This structure
contains the field Maintenance
operation to perform. This structure
contains the field Maintenance
operation. Valid values for this field
are:
are:
•
FACILITY_LOOPBACK
•
TERMINAL_LOOPBACK
•
PAYLOAD_LOOPBACK
maintenanceOperation
Mode
MaintenanceOperationMode_
T
In
Whether the maintenance
operation is completed or
released.
released.
Prime Optical support for CurrentMaintenanceOperation_T structure is as follows:
• globaldefs::NamingAttributes_T tpName
• globaldefs::NamingAttributes_T tpName
– Supported.