Cisco Cisco D9824 Advanced Multi Decryption Receiver Guia Da Instalação

 

236 

OL-29015-01 

1  From the user interface of the D9824, choose System Settings > Time/Clock. The 

Time/Clock page is displayed. 

2  From the Date Format drop-down list, choose the date format of the receiver. 

The following formats are supported: YYYY_MM_DD, DD_MM_YYYY, 
MM_DD_YYYY. 

3  From the Time Format drop-down list, choose the time format of the receiver. 

Current time information is normally broadcast as part of the transmitted digital 
signal. It is broadcast as GMT (Greenwich Mean Time) with date information in 
Modified Julian Date format. The following formats are supported: 24Hr, 24 Hr 
SuspendZero (the leading zero is dropped from the time), 12Hr, 12Hr 
SuspendZero (the leading zero is dropped from the time). 

4  From the GMT Time Offset drop-down list, choose the GMT offset. The local 

time is displayed using a time zone (GMT offset). If your local time is not GMT, 
you must set this time setting in the range from -12.0 to +12.0 hours in 0.5 hour 
increments. 

5  The Current TDT Time/Date field displays the current TDT (Time and Date 

Table) date and time received from the DVB stream. This is displayed as local 
time. 

6  Check the Enable NTP Time Service check box to periodically request NTP 

(Network Time Protocol) timestamps from the NTP server (NTP server address 
set below) and to synchronize its system (for example, non-DVB related) time 
with the NTP server. This is displayed as local time. 

7  In the NTP Server Address field, enter the IP address of the NTP server. If the 

NTP server address is not set (0.0.0.0), the unit will not attempt to connect to the 
server.  

8  The Current NTP Time/Date field displays the current time if the unit receives a 

valid reply from the NTP server, adjusted for local time zone.  

9  Click Apply.