Cisco Cisco Digital Service Access Node (DSAN) 8210 Guia Da Instalação
Chapter 3 Hardware Installation
52
78-4041038-01 Rev B
To Install the Crowbar Surge Protector
Complete the following steps to install the crowbar surge protector in the RF
module.
1 Begin this procedure with the housing open. Refer to To Open the Housing (on
module.
1 Begin this procedure with the housing open. Refer to To Open the Housing (on
2
Remove the RF module cover by loosening the 30 cover screws. Refer to the
following illustration.
following illustration.
Note: The RF module retaining screws, numbered 1 through 6, should remain
attached to the housing.