Cisco GainMaker Optoelectronic Node 1GHz with 65 86 MHz Split Guia Da Instalação
Chapter 2 Installation and Configuration
9 Route both fiber pigtails through the fiber access slot.
Note: Route excess fiber loosely through the fiber hold-down clips.
CAUTION:
Be careful not to damage the fiber or pigtails.
Be careful not to damage the fiber or pigtails.
10 Locate the proper fiber connectors and connect to the fiber bulkhead adapter.
11 Rotate the fiber management tray to its stored position. Refer to
11 Rotate the fiber management tray to its stored position. Refer to
To Stow the
Fiber Management Tray (on page 24).
12 Insert the AC power shunt directors.
Note: If supplying power to the node through the main input port, a power
inserter must be installed to terminate the RF signal.
13 Close the node housing. Refer to
To Close the Node Housing (on page 15).
42
OL-29644-03