Cisco GainMaker Optoelectronic Node 1GHz with 65 86 MHz Split Guia Da Instalação
Chapter 2 Installation and Configuration
To Remove or Reinstall the Optical Receiver
Important: While performing this procedure, be sure to observe the precautions for
handling an optical receiver.
Complete the following steps to remove or reinstall an optical receiver from the
Complete the following steps to remove or reinstall an optical receiver from the
optical section.
1 Open the node housing. Refer to
1 Open the node housing. Refer to
To Open the Node Housing (on page 17).
2 Remove the AC shunt power directors.
3 Rotate the fiber management tray out of its stored position. Refer to
3 Rotate the fiber management tray out of its stored position. Refer to
To Unstow
the Fiber Management Tray (on page 24).
Note: Using your index finger, pull up on the fiber tray pull-tab lever and rotate
Note: Using your index finger, pull up on the fiber tray pull-tab lever and rotate
the fiber management tray to partially expose the optical modules.
4 Loosen the fiber connector in the fiber management tray.
5 Using a flat-blade screwdriver, loosen the two mounting screws.
5 Using a flat-blade screwdriver, loosen the two mounting screws.
6 Pull the receiver out from the optical section.
a If you are not reinstalling the receiver at this time, proceed to step 10.
b If you are reinstalling the receiver now, proceed to step 7.
b If you are reinstalling the receiver now, proceed to step 7.
7 Insert the receiver in the appropriate slot and ensure that the receiver is seated
properly.
Note: Insertion slot is labeled on the optical interface board.
Note: Insertion slot is labeled on the optical interface board.
8 Use a flat-blade screwdriver to tighten the two mounting screws.
9 Route the fiber pigtail through the fiber access slot.
9 Route the fiber pigtail through the fiber access slot.
42
OL-30035-03