Cisco Headend System Release 2.5 Guia Do Utilizador
4011043 Rev B
Troubleshooting
11-7
Cannot Tune to Stream
Issue
Your receiver cannot tune to the stream you have selected.
Solution
If your receiver cannot tune to the stream, try the following:
•
•
Check that the ASI output port is connected to the ASI input port of the
modulator.
•
Check that the modulator RF output port is connected to the receiver RF input.
•
Check that the modulator is on.
•
Check the signal is attenuated sufficiently for the receiver (common cable
modulator problem).
•
Check the settings on the modulator, the delivery parameters in the
TSBroadcaster, and the tuning parameters on the receiver all match.
•
If you are integrating with an OCAP headend, check that the TSBroadcaster
parameters are consistent with the OCAP headend parameters.