Cisco Headend System Release 2.5 Guia Da Instalação
78-738190-01 Rev B
SR 2.5 and SR 3.5 Post Upgrade Procedures
5-27
Reset Modulators,
Continued
6.
Wait a few minutes and then from an xterm window on the DNCS, type
ping [IP address] and press Enter to ping each modulator you just reset.
Example: ping 172.16.4.4
Result: The ping command displays a message similar to Device is alive
Example: ping 172.16.4.4
Result: The ping command displays a message similar to Device is alive
when the modulator has been reset.
Note: It may take up to 5 minutes for each modulator to reset.
Note: It may take up to 5 minutes for each modulator to reset.
7.
Do you have additional modulators to reset?
•
•
If yes, repeat steps 3 through 6 as many times as necessary until all of your
modulators have been reset, and then go to step 8.
•
If no, go to step 8.
8.
Did you record the Program Count and the Session Count for each modulator
not used for VOD, as specified in step 1?
•
•
If yes, repeat step 1 to verify that the Program Count and Session Count
totals match what you recorded before resetting the modulators, and then
go to Reset QPSK Modulators, next in this chapter.
Important: If the Program Count and Session Count totals do not match
Important: If the Program Count and Session Count totals do not match
what you recorded prior to resetting the modulators, contact Cisco Services.
•
If no, go to Reset QPSK Modulators, next in this chapter.