Cisco Headend System Release 2.5 Guia Da Instalação
F-2
Setting Up the UniPack Alias
78-738190-01 Rev B
Set Up the UniPack Alias
Setting the UniPack Alias
Use these instructions to set up the UniPack alias on either the DNCS or the
Application Server.
Note: The ok prompt should be displaying on either the DNCS or the Application
Note: The ok prompt should be displaying on either the DNCS or the Application
Server, whichever is appropriate.
1.
At the ok prompt, type show-disks and then press Enter.
Result: The system displays a list of SCSI and ebus controllers.
Example: The list is in the following format:
•
Result: The system displays a list of SCSI and ebus controllers.
Example: The list is in the following format:
•
Enterprise 450 platform
/pci@1f,4000/scsi@2/disk
•
Enterprise 250 platform
/pci@1f,4000/SCSI@3,1/disk
•
Ultra 2 platform
/sbus@1f,0/SUNW,fas@e,8800000/sd
•
Ultra 5 platform
/pci@1f,0/pci@1/pci@2/SUNW,isptwo@4/sd
•
Sun Fire V880 platform
/pci@9,700000/pci@2/scsi@2,1/disk
2.
Type the letter of the hardware platform that corresponds to the computer
you are upgrading.
Important: Do not press Enter.
Important: Do not press Enter.
3.
Type nvalias unipack <Ctrl>y@3,0:b and then press Enter.
Note: For <Ctrl>y, press the Ctrl and y keys simultaneously.
Note: For <Ctrl>y, press the Ctrl and y keys simultaneously.
4.
Type devalias and then press Enter.
Result: The system displays a list of aliases for the various devices.
Result: The system displays a list of aliases for the various devices.
5.
Was the UniPack included in the list of aliases displayed in step 4?
•
•
If yes, return to the procedure you were following when you were directed
to this appendix.
•
If no, contact Cisco Services for assistance.